1. Avoid internal screen burn out Previously mentioned for a long time driving a liquid crystal display will reduce its life.So, in order to avoid the happening of this kind of situation, when not in use can adopt the following measures: 1) when not in use turn off the monitor;2) often changing in different time interval on the screen display content;3) will reduce the brightness of the display to the darker level;

2. Keep the environment humidity Don't let anything in the nature of moisture into the LCD, if the humidity has entered into the LCD, we must place the LCD to warmer and dry place, so that the water and organic compound evaporate, turn it on again.LCD with humidity, electric, can lead to LCD electrode corrosion, causing permanent damage.


3. Avoid unnecessary vibration can is one of the most sensitive electrical equipment, LCD LCD contains a lot of glass and sensitive electrical components, so that the screen is very fragile, try to avoid strong shock and vibration, the impact of the strong easy to cause the damage of the LCD screen and CFL unit.Be careful not to put pressure on LCD display surface, in front of the screen pointing bad habit must be correct.


4. Do not attempt to remove the LCD, there is a rule is, never remove the LCD.Even after shut down for a long time, background lighting component of CFL inverter still may have about 1000 v high voltage, the high pressure can result in serious personal injury.So never attempt to remove or change the LCD display, in order to avoid a high pressure.Without permission of the maintenance and change leads to display temporarily or permanently unable to work.If there is any fault suggest or get a professional repair station to repair.5. Usually it is best to use the recommended display resolution is entirely the display principle of LCD and CRT display is not the same.It is a direct way of corresponding display pixels.Work under the best resolution of LCD to display graphics output analog signal by processing, converted to take specific address information (the pixels on the screen the absolute address) of the display of the signal, and then into the liquid crystal panel, the display directly to the signal to the corresponding pixel on the drive pipe.In the case of such point-to-point output, use the display recommended best resolution is very important.